|
|
|
Who's Online
There currently are 5914 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
helpful manual.good service.Quick response.will use again
 ;
Speedy confirmation to my order , with elaborate instructions .
Item Email , received immediately as desired by me.
A Pleasant & Satisfying Transaction.
;
I was searching for this manual at last i got it from this web
;
What can i say but i would have been lost without your support.
Thank You!
;
Très satisfait ! envoi rapide, Grand catalogue disponible. Many thanks !
WARNING! This equipment is capable of producing sound pressure levels in excess of 85 dB, which may cause permanent hearing damage.
5. Accessories
Order code 1030-409 1030-404-V/H* 1030-405-V/H*
Figure 3 . XLR connection if unbalanced input is required.
Protective grille Wall mount Floor stand
Vertical / horizontal mounting
The speakers are normally delivered set up for vertical mounting. If horizontal mounting is needed the DCW plate may be rotated so that the GENELEC logo is located at the bottom left corner of the DCW. Remove the four corner screws of the DCW (use a Torx 20 screw driver) and pull the plate carefully out without stressing the wires or the gasket. Rotate the plate 90 degrees in the appropriate direction and remount the screws. Note that to get a mirror image pair, the DCWs must be rotated in different directions for the left and right speakers. When used in the horizontal position, the bass drivers should be on the inside to provide better low frequency summing.
warnings and cautions must be observed: Servicing and adjustment must only be performed by qualified service personnel. The amplifier's rear panel must not be opened, except by persons who are aware of the hazards involved. Do not use this product with an unearthed mains cable as this may lead to personal injury.
*State the desired speaker orientation V=vertical or H=horizontal when ordering these accessories.
�
6. Guarantee
This product is supplied with a one year guarantee against manufacturing faults or defects that might alter the performance of the 1030A unit. Refer to supplier for full sales and guarantee terms.
�
�
Console top mounting
If the 1030A's are used for console top monitoring, avoid mounting the speakers directly on the console. Instead position the speakers slightly behind the console by using floor stands or wall mounts. This prevents the reflection from the console surface from coloring the sound.
3. Maintenance
No user serviceable parts are to be found within the amplifier unit. Any maintenance or repair of the 1030A unit should only be undertaken by qualified service personnel.
4. Safety Considerations
Although the 1030A has been designed in accordance with international safety standards, to ensure safe operation and to maintain the instrument under safe operating conditions, the following
Figure 4. Rear panel layout.
|
|
|
> |
|
